ArchiveSCV
the-signal.com. The Santa Clarita Valley Signal. Back to the collection.

· signalscv.com, Wayback capture

Your Home Improvements

Robert Lamoureux: Permits, ponds and pipes

Question #1

Robert, I’m the board president on an HOA. We are looking to put a sign out front with the name of our association and have it lighted. Do we need city permits to do this? Rick J.

Answer #1

Rick, you’ll need permits for at least the electrical part of this project. This will be deemed a new circuit, so it will require a permit and inspection for this monument. I would also run this by the person at the counter of Building and Safety, and make sure that the city doesn’t have requirements or restrictions about the materials and style of monument that you are proposing to erect. You definitely don’t want to complete this project under the assumption that your placement and materials choices are ok with the city, only to find out that they have easement requirements and restrictions on materials choices. Whomever will be pulling your permits can discuss these topics with the representatives at Building and Safety, also showing a sketch as will be required. Good luck with this project.

Question #2

Robert, my name is Steve M. and I’m looking to put in a Koi pond in my backyard. I’m wondering what I need to do from a safety standpoint, am I supposed to put a GFI for this or does it not matter because this is a pond?

Answer #2

Steve, anything within 6 feet of water such as a sink, tub or even a pond outside; anything that people have contact with needs to have a GFI (ground fault interrupter) circuit. If it is a sump pump for instance, a mechanical device within a pit where a professional tradesman services it underground, this does not require a GFI but it must have a disconnect switch at that pump for service. The GFI shuts the power down immediately in the event that there is a short, which protects against electrical shock.

Question #3

Hi Robert, I always look forward to reading your column in The Signal. You always give great and helpful advice. We are planning to re-pipe our house soon. One plumber mentioned using PEX pipe and another plumber said copper pipe is the way to go. What do you think? Have you heard of PEX and is there anything negative about it? Or is copper pipe the better option? What about the costs between the two? (Our house is only 1,355 sq. ft.) I look forward to getting your advice. Thank you! Allen C.

Answer #3

Allen, thank you for writing in. I’ve been in the industry for almost 35 years. I’ve pretty much seen all of the options in plumbing. The PEX has a tendency to leak at the connectors and requires specialty tools to repair. Many plumbers won’t even work on the Pex. The copper has its issues also. Given the option between the two, I would go with the copper. It’s readily available for the repairs and the parts can be purchased at any box store. The Pex has to be purchased at a supply house and they often don’t have the parts in stock. When I re-piped my home I had the option to go with Pex and I stayed with type “L” copper. As long as the installer is good about honing the tube and cleaning the surfaces properly, you will not deal with leaks. Best of luck.

Question #4

My name is Daniel T. I own a commercial complex here in Santa Clarita, in the industrial center. About 4 years ago I had a white vinyl type roofing put on my flat roofs…like that swimming pool liner type system, and it was about mid-grade in quality. I hired a roofing contractor last year to go up and do a maintenance, but I did not go on the roof at that time. This year because of the predicted El Nino, I went up and looked at the roof. What I found was that they had put that black sticky product that you’ve talked about in your articles, I can’t remember the name, and then they sprayed it with white paint. My question is, is this the correct application or am I in trouble?

Answer #4

Daniel, I don’t know if you’re in trouble but whoever made that mess sure is in some trouble! It sounds like you’ve described Henry’s 208 which is used on modified systems and other types of roofs, not on TPO systems. If this is the TPO, the white vinyl, and you’ve gone to a mid-grade, that is a very expensive roof you’ve had put on. If you used a licensed contractor for these repairs and hopefully you did, he should make good on it. If not then you may end up having to call the original installer, if you can get hold of him, and he’s going to have to cut this all out. The beauty of the TPO system is that it is a heat weld, which means it is put on with what would be similar to a giant hair dryer, is the best way to describe it. It literally just melts on and it can be cut out in sections for repairs. Depending on how much Henry’s was put on and in how many places, this could get pretty costly. Without photos it is hard for me to tell you exactly what you’re dealing with. Should you end up in need of a local recommendation, get hold of me and I can help you. Good luck.

Robert Lamoureux has 38 years of experience as a general contractor, with separate licenses in electrical and plumbing contracting. He owns IMS Construction Inc. in Valencia. His opinions are his own, not necessarily those of The Signal. Opinions expressed in this column are not meant to replace the recommendations of a qualified contractor after that contractor has made a thorough visual inspection. Email questions to Robert at [email protected].

Image not recoveredKoi.jpg

← Back to 2015

About this record

How it was held, read and classified

Record details

Morris ID
144607
System
Morris section CMS (/section/…/article/… and /archives/…)
Reading copy
signalscv.com
Chosen by: only copy held. On this copy: words 988 (e-mail addresses counted as one token); reader comments 1 (counted, not reproduced here); images 1.
Extracted by
section_cms:articlebody_span
signal-extract/0.15 (2026-11-16)

Other copies

Held
None. The holding has this article from one host only.

How it was classified

Label
clearly-local
Judgment
A machine’s (recorded as machine), kept as one so it can be revisited.
Classifier
signal-localclass/0.7 (2026-11-12)
Local signals
  • text:valley_names [2 distinct/2 mentions: Santa Clarita, Valencia]
  • byline:named_writer_no_wire_credit [By Robert Lamoureux]
National signals
none fired
Scores
local 4, national 0