ArchiveSCV
the-signal.com. The Santa Clarita Valley Signal. Back to the collection.

· signalscv.com, Wayback capture

Your Home Improvements

Robert Lamoureux: On permits and elevated floors

Question #1

I see so many times where you say that work on a home needs to be permitted, so I am curious about what needs to be done at my home in Saugus. We have these big pylons holding up our entry overhang/roof, and the wood around them is coming undone.

It looks like there was caulking that is falling off, and the wood is literally coming apart and falling. Is this something that I need to get a permit for when I hire a contractor to fix it?

How do I know the reason that it’s coming off, how do I tell if it’s due to termites (our home was termite-free when we purchased it six years ago), or just age?

Please guide me on this; I need to get it fixed but I want to do it the right way. Thank you for all of your advice that you share; we love your article!

Answer #1

If you are just doing a column trim replacement, this will be a like-for-like repair and you won’t need a permit. Make sure that your column is sitting on a standoff bracket so that it is not sitting on bare concrete or in direct contact with soil. This will prevent any moisture from being wicked up the wood and causing rot.

Replacing the skirt, the decorative trim, should be a like-for-like job as well. The major key here during this replacement is that you need to prime and paint your new trim. Don’t do jsut one or the other — do both.

Primer helps the paint to stick, and the paint is a great barrier to all things horrible for wood.

Remember that this is something that is not a one-time thing; paint wears over time and, depending on how much sun it gets, will wear faster.

Be sure that you touch these areas up as needed, not just for aesthetics but — more importantly — for protection. All sides/ends need this protection; don’t leave any areas untreated.

This is very important. Good luck.

Question #2

Thank you for taking the time to help everyone who reads your article. I know many people personally who benefit from your expert advice.

I’ll be putting in new floors in my home and am considering what seems to be a big change. My formal living room steps down from the entry, and the formal dining that is attached goes back up.

What sort of a process and how big of a project would it be, to raise the formal living room ground floor to match the entry and dining, so that it is all one level? Does this have to be permitted and how would this be done? Is it an expensive thing to do?

Your best advice would be very much appreciated. Thank you.

Answer #2

Any time you are doing anything structural, meaning that there is any type of load either live or dead (people or materials) that will be on an area, this is a structural issue that will need an architect/engineer, and yes, permits.

You’ll be changing the configuration of this home and will need verification that this is being done in the safest way possible, especially due to the load factors. Here is a “for instance”: you raise this floor without proper load bearing techniques, then you bring in a grand piano to this room.

The flooring has not been built to withstand this type of load, and the next thing you know, your grand piano has fallen through your new floor and created a disaster. There is no insurance that will cover such a thing when it hasn’t been permitted, and more importantly with something like this, you could create a very hazardous situation.

Do yourself a favor and get this designed and permitted, or at the very least, find yourself a great contractor that can walk you through this process and help with those details.

As far as the cost, I don’t have dimensions or photos to go on so I’m imagining what you’re telling me. A project like this could end up quite costly, so I would fully check into it before committing to such a change. Good luck.

Robert Lamoureux has 38 years of experience as a general contractor, with separate licenses in electrical and plumbing contracting. He owns IMS Construction Inc. in Valencia. His opinions are his own, not necessarily those of The Signal. Opinions expressed in this column are not meant to replace the recommendations of a qualified contractor after that contractor has made a thorough visual inspection. Email questions to Robert at [email protected].

Image not recoverediStock_17096873_MEDIUM.jpg

← Back to 2016

About this record

How it was held, read and classified

Record details

Morris ID
153724
System
Morris section CMS (/section/…/article/… and /archives/…)
Reading copy
signalscv.com
Chosen by: only copy held. On this copy: words 772 (e-mail addresses counted as one token); reader comments 0 (counted, not reproduced here); images 1.
Extracted by
section_cms:articlebody_span
signal-extract/0.15 (2026-11-16)

Other copies

Held
None. The holding has this article from one host only.

How it was classified

Label
clearly-local
Judgment
A machine’s (recorded as machine), kept as one so it can be revisited.
Classifier
signal-localclass/0.7 (2026-11-12)
Local signals
  • text:valley_names [2 distinct/2 mentions: Valencia, Saugus]
  • byline:named_writer_no_wire_credit [By Robert Lamoureux]
National signals
none fired
Scores
local 4, national 0