Robert,
First, I just wanted to let you know how much I enjoy reading your home improvement column every Saturday in The Signal. You give very helpful advice.
I would like to scrape my acoustic (popcorn) ceiling but have been warned about the presence of asbestos. How can I know for sure? And, what should I do if asbestos is present? Thanks.
Don G.
Don,
First of all you have it tested.
The EPA, through NESHAP (National Emissions Standards for Hazardous Air Pollutants), banned any spray-on asbestos containing materials, mostly used as fireproofing, in 1973.
As a rule of thumb, any building-related ACM (asbestos containing materials) is a precursor to 1973. This is not to say there may not be traces of it afterwards, but it was supposed to have been completely phased out at that time.
Asbestos fibers are invisible to the unaided eye, but sometimes they stick together enough that you can see them. Some of the old-timers would scrape off a small piece of your ceiling and check it for threads; but when these fibers are disturbed they separate and become airborne. Once they are in the air, you run the risk of inhaling them which can be fatal. So, have it tested by professionals.
If asbestos is found, have an abatement company come in and take it down for you.
There are many EPA procedures in place for asbestos removal including keeping the material wet, to keep the fibers from becoming airborne, until it is properly contained through their emission control and waste treatment methods.
Hello Robert,
We purchased a four-plex apartment building recently and have been doing most of the repair work ourselves. There's one thing that I'm not too sure about. The balconies have stucco walls about four feet tall and about five inches wide. There is a metal cover that fits down on top of these walls that needs to be painted. I've already painted it once, but I pulled at a piece in the corner and the entire sheet of paint peeled off of it. It was the wrong color anyway, but why isn't the paint sticking? Also, there is water seeping out between the bottom of the wall and the deck, right underneath where the paint is peeling. Would you know how to address this? Thank you so much.
Randi H.
Randi,
The metal cover is what we call a parapet cap.
It sounds like you have a section of new cap, that wasn't sealed or etched before painting.
First, remove any existing paint off of this new section. Scrape it, sand it and feather it out. Check the joint between the new and old caps. Make sure that it is sealed properly with flashing cement. Water is draining down between this joint and flowing out at the deck. After this dries, you're ready for the paint.
You may want to leave the cap off for a couple of days to let the inside of the walls dry out. You don't want to seal it up with there being so much moisture in there.
New galvanized metal needs to be etched before painting or it won't stick. You can either purchase an etching solution or you can use a mixture of water and vinegar. The acetic acid in vinegar neutralizes the galvanizing and opens up the surface, which allows the paint to bond to the metal.
You mentioned the paint did not match. Scrape off some of the color you want and take it down to your favorite paint store. They will computer match it to 100 percent accuracy. It's amazing. I remember the old salts with the paint carousel. This was when color matching was an art form. They would mix it up by hand, paint a sample and dry it with a hair dryer to check it. Now, it's all done with computers.
Once you get your paint, go back and prime the surface with a metal primer. Let that dry and apply your paint.
Dear Robert,
We have two bedrooms upstairs and one of these bedrooms is always much colder than the other. The vent is open and I can feel heat coming into the room, but it's not as warm as the other rooms. The other bedroom actually gets too hot. Do you know why this is happening? How can I heat up this freezing room? Thank you.
Linda M.
Linda,
There are a couple of things you can do. You could close the diffuser and reduce the air flow going into the hot room, which would force more heat into your igloo; or you can balance the register.
For balancing, you would contact an HVAC company. They will cut your duct and install an in-line dampener. This basically works as a gate valve. It opens and closes to either allow or restrict air flow. Using an anemometer, or an air velocity meter, they will read the amount of air flow you have and adjust the dampener to equalize the volume of air flowing into each of your rooms.
Hey Robert,
I'm calling Roto-Rooter about every six months to clean out my sewer line. The tech told me that he found roots in the line, but there are no trees anywhere near my sewer line. How do I find out for sure what's causing the problem? Thank you.
David S.
David,
Run an underground camera and locator. This way you can visually inspect exactly what's going on inside that line.
If the tech said he found roots, then that's probably what it is. Roots are a common problem. Many times, the sewer line may not be where you think it is. It may be running alongside your neighbor's property, and if he has trees, then his roots are getting into your line. And, I get asked this all of the time, but no, your neighbor is not liable for his roots damaging your line.
One thing about roots is they never go away. Even after they're cut, they will continue to come back and get in through the hub band until you permanently address the situation.
So, once you find out where the roots are, dig it up and cut the roots back. Then, instead of backfilling, bury the pipe in concrete. First, wrap the pipe in burlap, then pour concrete around it to prevent the roots from getting in through that band again. This way, if you should ever have to make another repair, which is very unlikely, that burlap will prevent the concrete from bonding to the pipe and the concrete will break away easily.
Robert Lamoureux has 25 years' experience as a general contractor, with separate licenses in electrical and plumbing contacting. He owns IMS Construction Inc. in Valencia. His opinions are his own, and not necessarily those of The Signal. Opinions expressed in this column are not meant to replace the recommendations of a qualified contractor, after that contractor has made a thorough visual inspection.
Send your questions to [email protected].
