One in a series.
If I were 20 years younger I would go out and try to start an automobile company here in Southern California. Solving the problems that I have outlined in previous columns represents the biggest business opportunity in the next 20 years.
However, at age 72, I am only trying to publicize some ideas
that could help to solve these problems.
Therefore, I have deliberately not patented any of these ideas and have tried for over six years to get them published so that they could be considered in the ongoing debate.
The Airlectric system that I am going to describe is not the only viable alternative to battery and fuel cell cars. It is simply the best that I have found to date. I use it only to make the point that there are alternatives that the auto industry has chosen to ignore.
In my early studies of the three other ways, besides batteries, of taking energy from a wall plug and storing it in an auto, I quickly rejected compressed air because the air tanks required for even short range were too large to be practical.
However, I continued to study the possibilities of using compressed air to replace the small gasoline engines in lawn mowers, chain saws, etc. At that time, the average gas-powered lawn mower put out as much smog per hour as the average car.
I was designing and testing high-speed flywheels as a power storage system for cars. But that turned out to be a rather complicated system. At the same time I had also been coming up with a variety of ideas for minimizing the air consumption of the small air motors.
One day it occurred to me that, by including these new ideas, the air-powered car might be practical after all. Thus was born the Airlectric system.
The name comes from the fact that, while the stored energy is compressed air, the energy distribution system that I would use is the electric power grid, i.e., the 110 or 220 volts that are wired into practically every home in California.
In the Airlectric system you would have an electric motor-driven air compressor in your garage. At night, when electric demand is low, it would refill the tanks in the car. In the morning you would unhook the compressor from the car, leaving the compressor in the garage, and drive away. The stored heat unit would also be re-charged at night from an electric plug.
In order to minimize the size, i.e. the volume, of the air tanks, the air would be compressed to at least 3,000 psi. Similar tanks holding the compressed natural gas (CNG) already in use in trucks and buses are safety-certified for a life of 20 years. Since people were concerned about these tanks exploding in a collision, tests were done that indicated that these tanks, built strong enough to contain 3,000 psi, would not even leak in accidents violent enough to have killed everyone in the car. No other energy storage system can meet that criteria.
Compressed air is the safest way, that I know of, to carry stored energy. The tanks of breathing air that fireman wear on their backs hold air compressed to 4,500 psi.
Thomas Hanson is a Santa Clarita resident.
