ArchiveSCV
the-signal.com. The Santa Clarita Valley Signal. Back to the collection.

· the-signal.com, Wayback capture

Commentary

Humidity vs. your laser printer

The summer heat and sun bring us a lot more than unwanted freckles and sunburn.

Summer brings with it a number of problems not experienced during other times of the year. The main source of summertime office problems is humidity — the meeting of hot summer air and air conditioning. That is one of the reasons why large computer operations are housed in climate controlled computer rooms. Moisture has an adverse effect on laser printers, paper and other dry toner-based systems like copiers.

Paper, especially when it has a heavy rag content, will absorb moisture like a sponge. This is evidenced by excessive curling of the paper, resulting in paper jams and light print. The problem lessens as the top sheets are used and dryer sheets are reached farther into the stack.

It is recommended that a minimum amount of paper be kept in the paper tray and that other exposed paper be kept in plastic storage containers. These two steps will do a great deal to minimize the problem.

Unfortunately, laser printers cannot be stored in plastic containers. Most problems, whether with paper or printer, will occur more frequently in the morning — especially Monday mornings. Air conditioning is shut off or lowered over the weekend and at night, causing buildings to become significantly hotter than by day. When the air conditioning is turned back on, hot and cold air meet, causing excessive moisture build up in the air. This moist air settles on various parts of the printer and toner cartridge.

The two most vulnerable parts of the cartridge are the primary corona wire and the neoprene wiper blade, which removes excess toner from the print drum. In the printer, the most vulnerable part is the transfer wire under the crisscrossing wires inside the bottom of the printer. The transfer wire "transfers" the print from the drum to the paper. In each case, the moisture attracts dirt and dust like a magnet, causing streaks, blotches and light print.

Problems are more severe in older printers and machines that are not properly maintained, as well as machines that sit near open windows, over/under air conditioner ducts, in the sun or flush against the wall so that the printer doesn't properly exhaust. In most cases the problems are inevitable but can be controlled and minimized with proper care.

When the problems occur, a cotton swab can save the day. For cartridge problems, cleaning the corona wire in the cartridge will remove the moisture and dirt. The corona wire gives the instruction to put the print on the drum and then onto the paper. Since the dirt has no particular shape or size, it typically appears as streaks and blotches. This will occur in ALL Cartridges — New or Remanufactured, and that is why it is covered in the printer manual.

* * *

Russell Case, a Valencia business owner, specializes in computer printers, fax machines and copiers. "Technology Corner" appears Tuesdays and rotates among SCV high-tech professionals.

← Back to 1999

About this record

How it was held, read and classified

Record details

Morris ID
Not a Morris ID. This record is keyed ts-df:/business/tech/031699.html.
System
other
Reading copy
the-signal.com
Chosen by: only copy held. On this copy: words 497 (e-mail addresses counted as one token); reader comments 0 (counted, not reproduced here); images 0.
Extracted by
datefile:SLUG_to_rule
signal-extract/0.15 (2026-11-16)

Other copies

Held
None. The holding has this article from one host only.

How it was classified

Label
clearly-local
Judgment
A machine’s (recorded as machine), kept as one so it can be revisited.
Classifier
signal-localclass/0.7 (2026-11-12)
Local signals
  • text:valley_names [2 distinct/2 mentions: SCV, Valencia]
  • byline:named_writer_no_wire_credit [Commentary by]
National signals
none fired
Scores
local 4, national 0